Large-format tile and uneven edges
Updated 1 min read

What large-format means
Installers usually call a tile large-format when at least one side is 15 inches or longer. Large tile looks clean because it has fewer grout lines, but it demands a flatter floor.
Why edges end up uneven
The step between two neighbouring tiles is called lippage. A little is normal, and the industry standard allows for it. It stands out most with large tile, narrow grout joints and light coming in low across the floor. The Ceramic Tile Foundation names four main causes:
- A floor or wall that isn't flat enough.
- The natural slight bow in the tile itself.
- A long tile offset by more than a third of its length.
- Installation errors.
How flat the floor needs to be
Industry standards call for a floor that varies by no more than 1/8 inch over 10 feet when a tile has an edge of 15 inches or longer, and 1/4 inch over 10 feet for smaller tile. Many floors need grinding or a self-levelling compound to get there, which is why preparation takes up so much of a large-tile job.
Patterns and plank tile
Many large and plank tiles bow slightly in the middle, and a 50% brick pattern lines up those high points against the low ends. A one-third offset is the usual limit for long tile. Your tile's manufacturer may set its own, so check the box or the spec sheet.
What to ask before you buy
- Is the floor flat enough for this tile, and how will you check it?
- What will levelling add to the job?
- What offset and grout joint do you recommend for this tile?
- Will you lay out the room first, so cuts land where they won't show?
Levelling clips can help with minor differences on the day, but they don't make up for a floor that isn't flat.
Sources (secondary; the TCNA Handbook and ANSI A108 texts were not retrieved): Ceramic Tile Foundation, Three Lippage Hazards to Avoid; Stoneworld, How to Define Large-Format Tile and Its Subfloor Requirements; CTaSC, What is the acceptable lippage in a tile installation?.